Pricing available on request

ODS Thickness measurement:

• When linked, the ODS black-line sensors are calibrated to measure thickness.
• When the serial ports are linked to an identical model of ODS sensor, the ODS black-line sensor will automatically switch between being the master and the slave half of a thickness measuring system.
• After receiving the digital distance data from the slave sensor via the RS232 or RS422 serial interfaces, the master sensor reads it, factors in its own distance information, and outputs both the converted analog signal and the computed digital form of the thickness change.
• If the sensors are connected to measure at 1 kHz (half frequency), they will measure on transparent targets alternately from one side to the other and must always be synced.
• Thus, thickness or width can be measured using a couple of ODS sensors without the need for a control box or unique factory calibration.
• It is also possible to program the ODS sensors to function in difference mode rather than thickness measurement.