Back to Top
Controller for Machining On-the-Fly FS641
Flying operation controllers:
- Flying material processing makes use of the FS641 controller.
- A keyboard with a front-mounted pre-selection switch allows you to establish the cut-length specification easily and rapidly.
- The FS641 controller also includes a programmable switching function with 4 fast transistor outputs and an additional 4 potential-free change-over contact output relays that can be controlled.
Controller for Machining On-the-Fly:
- 2 pulse inputs in the following formats: A, B, 90° [HTL] or A, /A, B, /B [RS422].
- 4 control inputs for HTL, PNP, NPN, and Namur signals [10–30 VDC].
- The input frequency is up to 300 kHz.
- 4 fast transistor outputs, push-pull, short-circuit-proof at 5–30 VDC.
- 4 potential-free changeover relay outputs.
- 1 scalable 14-bit analogue output (0/4 − 20 mA or ±10 V).
- Cutting length can be specified using the keyboard or the front BCD decade switch.
- Power supply: 17–40 VDC and 24 VAC.
- Compact norm panel housing (according to EN 60715).
- Mounting the top hat rail with the SM600 support brackets is an option.
- Setup can be done with keys or on a PC using a serial RS232 interface.
- PROFIBUS connection through the Motorola PB251 gateway.
| Brand | Motrona |
|---|
Write Your Own Review
Write your content here...
